Skip to content
Shepherd and Sons Contracting Ltd logo

Service

Joint Sealing Contractors in Sussex

We seal joints across Sussex from our yard at Linton near Maidstone. East Sussex is reached along the A21 and A272, West Sussex down the A23 and M23, and both are inside a normal working day. The work is mostly bridges and highway structures, carriageway joints along the main corridor, and port and coastal surfaces at Shoreham and Newhaven.

Two sealants on one bridge at Lyminster

At Lyminster, a West Sussex village near Arundel, we sealed a bridge under Breheny Civil Engineering. The structure needed two different sealants because it had two different kinds of joint.

  • Expansion joints took Fosroc Thioflex 600 in hand grade. A bridge expansion joint follows real seasonal movement, so it needs a polysulphide with the extension to keep up, and a hand grade because the joints are not all horizontal and a pouring grade will not stay on an upstand.
  • Surface joints in the carriageway were saw cut and sealed in Craftco N1, a hot applied sealant, where the requirement is a durable, level, trafficable finish rather than maximum extension.

Hot or cold applied

Hot applied sealants are classified under BS EN 14188-1. N1 is the high extension grade for carriageway joints that move a lot, and N2 the lower extension grade for stable joints. Neither is fuel resistant; that belongs to the F grades. Cold applied sealants fall under BS EN 14188-2, and a two-part polysulphide such as Thioflex 555 is the usual answer where a joint will see fuel, as on an airfield or a forecourt.

When to seal

Sealant needs a dry joint and a surface warm enough to bond, so the weather decides when a programme can run. Spring into early summer gives the most reliable results. Mid-summer heat softens asphalt joint walls, and a frost on uncured sealant late in the year means the work is done again the following spring.

What to check before appointing anyone

  • Which sealant grade, and why that one for this joint?
  • How will the joint be prepared: cut to what width and depth, cleaned how, and primed if the data sheet calls for it?
  • Is a backer rod going in to stop the sealant bonding to the bottom of the joint?
  • Can the same firm cut and seal, or is that two appointments?

For joint sealing anywhere in Sussex, from the A23 corridor to the coast, get in touch with our team.

More of our work in Sussex

Shepherd and Sons Contracting LTD

Contact Us